Finding the perfect new bathroom fixtures is only half the battle, the next step is getting your old hardware out and installing the new hardware to complete your updated look.
Step 1:
Pick your faucet. If your sink already has a single stem faucet might be wise to stick with that style and the same for three stem systems.
Step 2:
Turn off the water! Under your sink there are two knobs, one for hot water and one for cold, make sure both are off, and then open the faucet to let any built-up water run out.
Step 3:
Remove the old faucet. Disconnect the water supply lines. If you are going to replace the supply lines, now is the time, and you should also disconnect them from the shut-off valve. If not, skip that step. Remove the faucet and clean the holes in your sink with rubbing alcohol.
Step 4:
Figure out if you have a top mount or bottom mount faucet. For the top mount, continue to step 5, for the bottom mount, continue to step 7.
Step 5:
Put a bit of plumber caulk around the base of your faucet and ease the faucet into place. Press against the caulk to ensure a good seal.
Step 6:
Head under the sink. Install the washers and mounting nuts onto the tailpieces of the faucet above. Align the faucet with the back of the sink, and tighten the nuts with pliers or a wrench.
Step 7:
Head under the sink, and hold the faucet in place. Install the washers and mounting nuts, tightening them by hand. Align the faucet with the back of the sign before tightening the nuts with pliers or a wrench.
Step 8:
Install the faucet handles, hot usually goes on the left and cold on the right. Wipe away extra caulk and you are all set!
Step 9:
Attach your supply lines, turn on your water and enjoy your newly updated bathroom!
Let Plumbtile help you choose your new fixtures today! We have a large variety of bathroom faucets that would fit your needs and decor.